Your current location : Home >> News >> Company news

Handle lock manufacturer introduces handle lock disassembly

2021-04-17 05:30:36
Times

Every day, we will inevitably use or touch the door lock, one of which is called the handle lock. What is the handle lock, how to install the handle lock, how to remove the handle lock, and so on. Some problems are that people are curious and interested in the handle lock after they come into contact with the handle lock, so how to remove the handle lock?


执手锁


Installation of handle lock:

1. Cut the specification drawing of the installation paper and attach it to the appropriate height of the door (the center of the rest assured hole is about 1m above the ground).

2. According to the left and right door opening, adjust the inclined direction of the inclined tongue, close the door, then put the lock into the lock hole and fix it with self tapping screw.

3. Insert the lock body into the pre opened slot, fix the lock body with screws, insert the square core into the square hole of the lock body, insert the square hole of the handle of the front and rear panel into the square core, screw in two fastening screws (not tightened temporarily) on the inner panel, pass the lock cylinder from the door to the outside through the lock cylinder hole, and fasten the lock cylinder and the lock body with the lock cylinder fixing screws, Then tighten the two fastening screws on the inner panel.

In the corresponding position of the door frame, dig out the buckle box hole and the buckle plate support nest, install the buckle box and the buckle plate, and fix them with self tapping screws to make the lock tongue expand freely.

How to remove the handle lock:

Look at the handle of the lock in the relative internal direction. There is a small hole in the small part of the handle. Use hard and thin things (such as nails) to insert, hold firmly, and then pull out the ball of the handle.

Turn the plate on the door counter clockwise, and you will see two screws. Remove them with a cross wire cutter and pull out the ball center from the opposite outside.

The lock core can be pulled out by removing two tired wires from the tired wire knife beside the door.


Prev:What is handle lock2021-04-17
Next:None

Recently Viewed:

  • Home
  • Tel
  • Top