Your current location : Home >> News >> Industry information

"Guangdong handle wholesale" teaches you the correct installation of handle lock and installation precautions

2020-11-20 09:49:41
Times

Guangdong handle wholesale introduction teaches you to install handle lock correctly

Precautions for door lock installation

1. Look at the lock handle in the opposite direction. There is a small hole in the small part of the handle. Insert it with a hard thin thing (such as a nail) to hold it firmly, and pull the handle ball out.

2. Turn the disc on the door counter clockwise, and you will see that there are two screws. Remove them with a cross wire knife, and pull out the ball center from the opposite outside.

3. The lock core can be removed from the wire knife by the door, and the two wires can be pulled out.

Sometimes, due to the gravity of the door leaf itself or the loose leaf of the door, the door leaf sinks, and the phenomenon of locking or opening the door is not smooth appears. At this time, it is often very difficult to open and lock the door with the key. At this time, don't twist the key to avoid breaking the key and adding trouble.

The right solution: check the reason first. If the loose leaf causes the door leaf to sink, the loose leaf should be fixed tightly with screws. If the door frame is deformed or irrecoverable due to its reasons, start from the door frame and expand the lock tongue accordingly. In this way, the door lock can be opened and closed normally.

How to install the handle lock

1. Cut out the appropriate height of the installation plan attached to the door (the center of the relief hole is about 1m above the ground).

2. According to the left and right door opening, adjust the inclined plane of the inclined tongue to the closing direction, and then put the lock body into the lock body hole and fasten it with self tapping screw.

3. Insert the lock body into the slot opened in advance, fix the lock body with screws, insert the square core into the square hole of the lock body, insert the square hole of the handle on the front and rear panel into the square core, screw in the two fastening screws (not tightened temporarily) on the inner panel, pass the lock cylinder from the door to the outside through the hole of the lock cylinder, fasten the lock cylinder and the lock body with the fixing screws of the lock cylinder, and then tighten the two fastening screws on the inner panel.

4. Chisel out the buckle box hole and buckle plate support socket at the corresponding position of the door frame, install the buckle box and buckle plate, and fasten them with self tapping screws, so that the lock tongue can expand freely.


执手锁安装


Guangdong handle wholesale introduction installation precautions

What I want to say here is that the use frequency of locks is very high when I go in and out of the room every day. Therefore, I suggest that when I buy Locks, I must pay attention to the quality. A good lock feels very strong, and it's very heavy to weigh it. Of course, the price is not cheap. But it's not necessarily good if the price is expensive. Xiao Bian shares her experience with you

1. Business must be formal, this is the premise, formal business will not deceive consumers.

2. Whether the workmanship is exquisite depends on the care, and whether there are flaws on the surface.

3. Look at the locking tongue. It needs enough elasticity.

4. If you turn the handle, it depends on the elasticity.

5. The lock cylinder is made of copper, so it's heavy.

Guangdong handle wholesale manufacturers

Where there are buildings, there are building hardware beside the field! Tianbian hardware makes every user feel the enjoyment of modern science and technology building hardware system, makes all buildings using Tianbian hardware products more beautiful, energy-saving and environmental protection, and becomes the most beautiful landscape in the city.


Recently Viewed:

  • Home
  • Tel
  • Top